PI Wind Direction - Calibration for METOS 5 and μMETOS

Modified on Thu, 5 Mar at 10:43 AM

This article explains when and how to use the calibration option for the PI Wind Direction sensor on METOS 5 and μMETOS devices.

Important Notes Before You Start

1. PI wind direction sensors are factory‑calibrated, and in most cases no user action is required.
However, METOS 5 and μMETOS devices provide an additional calibration function for special situations where the sensor must be aligned or recalibrated at the final installation site.

2. The additional calibration option available in:

METOS 5
μMETOS

3. Recalibration should be performed at the installer’s discretion, typically in situations such as:

Reinstallation or repositioning of the sensor
Alignment adjustments after mounting
Site-specific structural influences affecting direction accuracy

➡️ If the sensor is properly installed and aligned to true North, recalibration is generally not necessary.

Manual & Detailed Procedure

For detailed step-by-step calibration instructions, please refer to the official manual.

➡️ The manual is available for download as an attachment below this article.

Need Help?

If you encounter issues during this process or are unsure about the information on this page, please SUBMIT A TICKET to the METOS Support Center.

SUBMIT A TICKET

Attachments (2)

pdf

Calibration of PI Wind direction with Metos 5 FW.pdf
374 KB

pdf

Calibration-of-PI-Wind-direction-with-µMetos-FW-1.pdf
1.75 MB